17.1.11 Thorough check of the response time of the safety system within the target application
Response time of the safety system within the target application
T
able 110: Response time of the safety system within the target application
Check sequence Expected result Result OK?
1. Determine the response time of
t
he safety system within the tar‐
get application (e.g., by measur‐
ing the stopping time).
The response time of the safety system
within the target application is appro‐
priate.
Yes No
Comment:
17.1.12 Thorough check of the check intervals
Thorough check of the check intervals
T
able 111: Thorough check of the check intervals
Check sequence Expected result Result OK?
1. Set a check interval for regular
t
horough checks and validation
of the safety system on the basis
of the risk assessment for the
application.
2. Specify a responsible party.
The check interval and responsible
party have been defined as follows:
Yes No
Check interval:
Responsible party:
ANNEX 17
8020941/12O9/2019-08-05 | SICK O P E R A T I N G I N S T R U C T I O N S | Safe Linear Positioning
95
Subject to change without notice
To Next Page
Loading...
Need help?
General
