Siemens 7SJ82 - Page 1232

No. Information Data Class
(Type)
Type
_:14011:326 90V V.contr.2w:Cmd. with feedback BALANCED
SCORECARD
C
_:14011:329 90V V.contr.2w:Block auto SPC C
_:14011:312 90V V.contr.2w:Operating mode SPC C
_:14011:305 90V V.contr.2w:Bandwidth > SPS O
_:14011:306 90V V.contr.2w:Bandwidth < SPS O
_:14011:307 90V V.contr.2w:Fast Step Up active SPS O
_:14011:308 90V V.contr.2w:Fast Step Down active SPS O
_:14011:309 90V V.contr.2w:Auto Monitor SPS O
_:14011:310 90V V.contr.2w:Vmin Limiting SPS O
_:14011:311 90V V.contr.2w:Vmax Limiting SPS O
_:14011:315 90V V.contr.2w:Auto Blocking SPS O
_:14011:316 90V V.contr.2w:Manual Blocking SPS O
_:14011:317 90V V.contr.2w:V< Blocking SPS O
_:14011:318 90V V.contr.2w:I> Blocking SPS O
_:14011:319 90V V.contr.2w:I< Blocking SPS O
_:14011:320 90V V.contr.2w:V act. MV O
_:14011:321 90V V.contr.2w:ΔV act. MV O
_:14011:322 90V V.contr.2w:I load MV O
_:14011:323 90V V.contr.2w:V max MV O
_:14011:324 90V V.contr.2w:V min MV O
_:14011:325 90V V.contr.2w:V target MV O
_:14011:354 90V V.contr.2w:Target voltage 1 SPC C
_:14011:355 90V V.contr.2w:Target voltage 2 SPC C
_:14011:356 90V V.contr.2w:Target voltage 3 SPC C
_:14011:357 90V V.contr.2w:Target voltage 4 SPC C
_:14011:358 90V V.contr.2w:Set target voltage APC C
_:14011:359 90V V.contr.2w:Block T1 SPC C
Three-Winding Transformer
No.
Information Data Class
(Type)
Type
General
_:2311:52 General:Behavior ENS O
_:2311:53 General:Health ENS O
Tap changer
_:13981:500 Tap changer:>Acquisition blocking SPS I
_:13981:501 Tap changer:>Enable SPS I
_:13981:53 Tap changer:Health ENS O
_:13981:301 Tap changer:End higher pos.reached SPS O
_:13981:302 Tap changer:End lower pos.reached SPS O
_:13981:308 Tap changer:Position BALANCED
SCORECARD
C
_:13981:305 Tap changer:Higher command SPS O
_:13981:306 Tap changer:Lower command SPS O
_:13981:307 Tap changer:Command active SPS O
Control Functions
8.9 Voltage Controller
1232 SIPROTEC 5, Overcurrent Protection, Manual
C53000-G5040-C017-8, Edition 07.2017