Logging 9410 series
Logging
Logging overview
The meter is equipped with data recorders, waveform recorders and event logs that
enable you to log and monitor various metering functions and features.
Your meter has a number of onboard default logs (also called data recorders) that are
used to store data related to:
• Power quality and compliance
• Trending and forecasting
• Energy/revenue metering
• Meter events
Your meter also logs voltage and current waveform data when a sag or swell is
detected. You must enter your power system’s nominal values and configure your
meter so that it can identify sags and swells; and you can enable current waveform
recording if it is required for your system. You can configure your meter’s setpoint
learning feature to learn your power system’s normal operating values and use that
information to help identify voltage sags and swells.
Logged data can be retrieved by energy management software.
Related Topics
• Minimum configuration requirements for basic metering
Data logging overview
Your meter has data logging capabilities, including a special type of data log which is
an event log, which logs prioritized events.
Data logs are recorded by your meter and stored in the meter’s memory inside
configurable data logs. Your meter’s data logs are retained if the meter loses power.
Logged data can be used by energy management software. Logs can be configured to
either overwrite the oldest data when full (circular), or to stop writing data to the log
when the number of logged records reaches the maximum log depth (stop-when-full).
Your meter ships with a comprehensive data-logging configuration consisting of data
logs set up to record values at specific intervals or on conditions. Your meter’s default
data logging configuration should be sufficient for most applications, but you can also
reconfigure existing logs or create new logs for custom applications if needed.
Your meter can also be configured to email data log information.
NOTE: Adding or deleting data logs or their parameters outside of the ION Setup
Assistant should only be undertaken by those with an advanced understanding of
ION architecture and their meter’s template.
See the Internal email client feature technical note, available from
www.usa.siemens.com/pds, for instructions on how to configure your meter to email
logged data.
See the ION Reference, available from www.usa.siemens.com/pds, for more
information about ION architecture and ION modules.
7EN05-0336-03 119
To Next Page
Loading...
Need help?
General
