Siemens 9410 Series - Advanced Log Setup and Memory Optimization; Viewing Log Configuration and Memory Usage Information

Logging 9410 series
record the associated event, set the alarm priority to Info Only. To disable the
alarm and the event, set the alarm priority to None.
See the ION Reference, available from www.usa.siemens.com/pds, for more
information about the Event Log Controller module and event priorities for specific ION
modules.
Related Topics
• Alarms overview
Default waveform recording configuration
Your meter’s waveform recording operates once your nominal values are configured.
Your meter has the following default waveform recorders:
Waveform recorder Description
Wfm Rc V1-Sg/Sw V1 voltage waveforms recorded during a defined sag or swell event.
Wfm Rc V2-Sg/Sw V2 voltage waveforms recorded during a defined sag or swell event.
Wfm Rc V3-Sg/Sw V3 voltage waveforms recorded during a defined sag or swell event.
Wfm Rc I1-Sg/Sw I1 current waveforms recorded during a defined sag or swell event.
Wfm Rc I2-Sg/Sw I2 current waveforms recorded during a defined sag or swell event.
Wfm Rc I3-Sg/Sw I3 current waveforms recorded during a defined sag or swell event.
Advanced log setup and memory optimization
You can configure your meter’s logs to help ensure the integrity of critical data and to
optimize the meter’s memory usage.
Before you configure your meter’s logs, it is important to understand how logging
functions and how the settings work together.
NOTE: Configuring your meter’s logs requires an in-depth understanding of the
meter’s memory, how the logs function and the data you are capturing.
Viewing log configuration and memory usage information
You can use ION Setup to view log settings and memory usage information for your
meter’s default logs.
This information can help you understand your log usage and how to optimize your
logging configuration for your situation.
1. Start ION Setup.
2. Open the Setup Assistant for your meter.
3. Navigate to the Logging > Memory screen.
The Status tab:
• lists the default logs, their interval (Duration) and depth (Records), if
applicable, and the percentage of available memory used by the log.
• provides information on how much of the meter’s memory is used for system
tasks in the System Resources list item.
• displays the total meter memory and the percentage of memory in use versus
memory available.
7EN05-0336-03 129