Siemens 9410 Series - Option I;O Modules Configuration

Inputs / outputs 9410 series
for your energy system. For applications requiring high accuracy, such as energy
pulsing to verify accuracy, the digital output on the meter base is recommended.
Your meter’s digital and analog outputs may change state during a firmware upgrade.
Option modules are offline during an option module firmware upgrade; they will not
communicate to the meter and the outputs may change state during the upgrade
process.
Your meter’s analog I/O option modules can measure and output either low voltage or
current using standard analog transducers such as 4 - 20 mA current transducers.
Analog I/O option module data viewing
View analog I/O option module data from the webpages and display.
To view analog option module data on your meter’s display, go to Inputs/Outputs and
select either Analog Inputs or Analog Outputs. If there are no I/O of the specified
type, an informative message is displayed.
To view analog option module data on your meter’s webpages, connect to your meter’s
webpages, go to Monitoring > Inputs/Outputs and select either Analog Inputs or
Analog Outputs. If there are no I/O of the specified type, an informative message is
displayed.
Digital I/O option module data viewing
View digital I/O option module data from the webpages and display.
To view digital option module data on your meter’s display, go to Inputs/Outputs and
select either Digital Inputs or Digital Outputs. If there are no I/O of the specified type,
an informative message is displayed.
To view digital option module data on your meter’s webpages, connect to your meter’s
webpages, go to Monitoring > Inputs/Outputs and select either Digital Inputs or
Digital Outputs. If there are no I/O of the specified type, an informative message is
displayed.
Option I/O modules configuration
You can configure your meter’s I/O option modules using ION Setup.
The I/O option module screen has tabs corresponding to the possible option modules,
which are identified based on how the option modules are connected to the meter.
Each tab indicates the module’s type and status, and has an area where the module’s
ports are listed for viewing and configuration. You can also reset your meter’s option
modules using ION Setup.
Status examples Description
None No option module detected
Normal The option module is operating normally
Option module added A new option module is detected
Option module removed The option module has been removed
Invalid SI9 The option module’s firmware is not supported
Invalid card The option module type is not supported
7EN05-0336-03 137