Siemens 9410 Series - Page 127

Logging 9410 series
Harm Mean Log
I2 THD mean
I3 THD mean
Harm High Log
V1 THD high I1 K Fac high
V2 THD high I2 K Fac high
V3 THD high I3 K Fac high
I1 THD high
I2 THD high
I3 THD high
Energy/Demand log
The Energy/Demand log records energy and demand data used by energy
management software to generate reports. Changing the logged data can prevent the
generation of reports that use this data.
Sag/swell log
The Sag/swell Log provides details of power quality events. By default, it logs the
following values:
SS1 DistDur SS1 DistV1Min SS1 DistV1Max SS1 DistV1Avg
SS1 DistV1Engy SS1 DistV2Min SS1 DistV2Max SS1 DistV2Avg
SS1 DistV2Engy SS1 DistV3Min SS1 DistV3Max SS1 DistV3Avg
SS1 DistV3Engy SS1 DistNominal SS1 Swell Lim SS1 Sag Lim
EN50160 compliance logs
The EN50160 compliance logs are used to record EN50160 compliance parameters:
Data recorder EN50160 component logged
EN50160 Frq/Mg Power frequency and supply magnitude
EN50160 Hrm Vlt Harmonics
EN50160 Intrp Short/log interruptions
EN50160 Ovrvlt1
Temporary overvoltage
EN50160 Ovrvlt2 Temporary overvoltage
EN50160 Prm-f/V
Parameter data (disabled by default)
EN50160 Prm-VIr Parameter data (disabled by default)
EN50160 Vunbal Voltage unbalance
EN50160 PrmHrm1
Parameter data (disabled by default)
EN50160 PrmHrm2 Parameter data (disabled by default)
EN50160 Vlt Dp1 Supply voltage dips
EN50160 Vlt Dp2 Supply voltage dips
EN50160 Vlt Dp3 Supply voltage dips
7EN05-0336-03 127