9410 series Power quality
A. Select the COMTRADE module to view
(COMTRADE_1 is set up by default; you
can also set up COMTRADE_2 or
COMTRADE_3)
B. Select the particular COMTRADE
waveform to view
C. Show / hide parameters
D. View details
E. Zoom in / out
Related Topics
• Default meter webpages
Viewing waveforms on your meter’s webpages
Use the waveform viewer on your meter’s webpages to view the meter’s COMTRADE
waveform files.
Before you can view waveforms on your meter’s webpages, you need to make sure
your meter is configured to record waveforms by setting the nominal voltage.
1. Launch a browser and go to the IP address for your meter, entering valid login
credentials when requested.
2. Go to the Monitoring tab and select Waveforms.
A screen displays with accordion menus for all 3 COMTRADE modules
(regardless of whether or not that COMTRADE module is being created by the
meter). The waveform viewer for COMTRADE_1 is expanded.
By default, COMTRADE_1 displays the sag/swell waveform records.
COMTRADE_2 and COMTRADE_3 are used if you have configured additional
waveform recorders and connected them to COMTRADE modules.
3. Select the accordion menu for the COMTRADE records you want to view, for
example COMTRADE_2.
The waveform viewer for those COMTRADE records is displayed.
4. Select the file you want to view from the record dropdown.
The numbering starts at 0 (zero), which means you select cmt0_00004 to view the
fifth file for COMTRADE_1.
182 7EN05-0336-03
To Next Page
Loading...
