Communications 9410 series
Your meter supports a maximum of three concurrent connections (sessions) using the
DNP 3.0 protocol; one for each serial port, up to three using Ethernet, or a combination
of both. Combinations available depend on the meter's communications options. A
session consists of all incoming and outgoing DNP Master/Slave traffic on one of the
meter's communications ports.
For serial DNP communications, you must assign the DNP protocol to the appropriate
serial communication port on your meter; you do not have to configure your meter’s
Ethernet port(s).
You can modify your meter’s default DNP map using configuration software.
Data can be imported into the meter from a DNP control relay or analog output device.
This is an advanced feature intended for users with an in-depth understanding of the
DNP 3.0 and ION protocols.
See the online ION Setup help for instructions on connecting to your meter and
accessing the Setup Assistant, which can be used to modify your meter’s DNP port
settings and default DNP map. Go to www.usa.siemens.com/pds to download your
meter’s DNP 3.0 device profile document for detailed information on your meter’s
default DNP map and implementation and the Multiport DNP 3.0 and ION technology
technical note for more information on how your meter supports DNP 3.0.
7EN05-0336-03 93
To Next Page
Loading...
Need help?
General
