e1249d1
25
Fire & Security Products
Siemens Building Technologies Group
01.1999
3.6 First switch-on
Check whether the batteries are connected.
Apply supply voltage Observe safety guidelines
the CC/CI/CT11 stations load a basic configuration stored in EPROM into the RAM.
After approx. 2 minutes this start-up procedure is concluded.
Master Module E3X101 (E3X100)
Green LED on CPU module
3
flashes ( see page 24)
irregular flashing: lit phase clearly shorter than the unlit phase (approximate period
length: 1 second)
Green battery indicator LED
4
Lights up( see page 24)
Control unit CI11 or Terminal CT11 (B3Qxxx)
LCD display gives the following INFORMATION:
INFORMATION Total: 1
******** load data ********
select MESSAGE CATEGORY F1:function
CT11 and CC/CI11 only communicate with each other after the system configuration
has been loaded into the stations.
Control unit is ready for the localization of interactive or AnalogPLUS devices or data
transfer from the maintenance PC.
To Next Page
Loading...
