9 Operation at Use of a PC
9.3 Configuration of the Device
204 SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019
Figure 9-51 Configure Tab, Mains Signaling Voltage Input/Output Window
✧ Select the desired parameters in the list boxes and option fields as described in Table 9-18.
✧ After the parameterization, click Send.
The parameters are transmitted to the device but not enabled yet (passive set of parameters).
If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of Parameters.
MAN_SICAM_Q100_US.book Page 204 Wednesday, June 5, 2019 9:31 AM
To Next Page
Loading...
