Siemens SIMATIC HMI series System Manual

1.3 SIMATIC WinCC: Product compatibility and supported functions
To use the software with other SIMATIC products you must ensure that the product versions
match and support the required functions.
●
You determine the version compatibility with the compatibility tool.
●
Note the additional information on the products and functions
SIMATIC Process Historian
Note which functionality is supported by the SIMATIC Process Historian version that is used
in each case. For additional information, refer to the documentation for the SIMATIC Process
Historian.
Compatibility tool
With the compatibility tool, Industry Online Support gives you a function you can use to put
together a compatible selection of software products or to check existing configurations for
compatibility.
In the following entry you can call the compatibility tool and find additional information on the
operation of the tool:
● https://support.industry.siemens.com/cs/ww/en/view/64847781 (
https://
support.industry.siemens.com/cs/ww/en/view/64847781)
WinCC Installation Notes
1.3 SIMATIC WinCC: Product compatibility and supported functions
WinCC: General information and installation
10 System Manual, 02/2017, A5E40840020-AA

Siemens SIMATIC HMI series Specifications

General

Series	SIMATIC HMI
Category	Control Panel
Display Type	TFT LCD
Touch Screen	Yes (resistive or capacitive, depending on model)
Processor	Varies by model (e.g., ARM-based processors)
Storage	Varies by model (e.g., Flash memory, microSD card slot)
Communication Interfaces	Ethernet, USB
Protection Class	IP65 (front panel), depending on model
Operating Temperature	0 to 50°C, -20 to 60°C
Power Supply	24 V DC
Memory	128 MB, 256 MB