Siemens SIMATIC HMI series - Count of Actions in Cycle

6.3.5.7 Count of Actions in Cycle
Description
Menu command
"Count of Actions in Cycle" lists the amount of cyclic actions sorted by trigger.
In this case, the numerical values correspond with the following triggers:
0 250 ms
1 500 ms
2 1 s
3 2 s
4 5 s
5 10 s
6 1 min
7 5 min
8 10 min
9 1 h
10 - 14 User cycle 1 - 5
Example
===============================================================
Count of Actions in Cycle (0): 6
Count of Actions in Cycle (1): 5
Count of Actions in Cycle (2): 0
Count of Actions in Cycle (3): 6
Count of Actions in Cycle (4): 0
Count of Actions in Cycle (5): 1
Count of Actions in Cycle (6): 0
Count of Actions in Cycle (7): 0
Count of Actions in Cycle (8): 0
Count of Actions in Cycle (9): 0
Count of Actions in Cycle (10): 0
Count of Actions in Cycle (11): 0
Count of Actions in Cycle (12): 0
Count of Actions in Cycle (13): 0
Count of Actions in Cycle (14): 0
===============================================================
WinCC diagnosis
6.3 ApDiag Menu Commands
WinCC: General information and installation
184 System Manual, 02/2017, A5E40840020-AA