Siemens SIMATIC HMI series System Manual

5.3 Conditions for Migration
Introduction
You
can
migrate a WinCC project on any computer on which WinCC V7.4 has been installed.
The WinCC Project Migrator is included in the standard installation scope of WinCC V7.4.
Use Project Duplicator to copy the configuration data of the project to the migration computer.
For information on copying projects, refer to the "Working with projects" > "Copying and
duplicating projects" section in the WinCC Information System.
The code page settings of projects that you want to migrate in a single step must be uniform.
Requirements
The computer on which the migration should be performed must fulfill the following conditions:
Requirement
Operating system The requirements are specified in the "Hardware requirements" and
"Software requirements" section of the installation instructions.
CPU
RAM
Free memory space on the
hard disk
In addition, at least the size of the overall project. Migration increases
the size of the projects.
User Rights User must be a member of the "SIMATIC HMI" group
WinCC version installed WinCC V7.4
WinCC version project data WinCC V7.3, V7.2, V7.0 or V6.2 SP3
Licenses New V7.4 RC license or RT license for PowerTags
System status WinCC closed:
●
Runtime deactivated
●
WinCC Editors closed
● WinCC Explorer closed
See also
How to migrate SQL Server 2000 databases (Page
142)
Migration
5.3 Conditions for Migration
WinCC: General information and installation
System Manual, 02/2017, A5E40840020-AA 141

Siemens SIMATIC HMI series Specifications

General

Series	SIMATIC HMI
Category	Control Panel
Display Type	TFT LCD
Touch Screen	Yes (resistive or capacitive, depending on model)
Processor	Varies by model (e.g., ARM-based processors)
Storage	Varies by model (e.g., Flash memory, microSD card slot)
Communication Interfaces	Ethernet, USB
Protection Class	IP65 (front panel), depending on model
Operating Temperature	0 to 50°C, -20 to 60°C
Power Supply	24 V DC
Memory	128 MB, 256 MB