Siemens SIMATIC HMI series System Manual

WinCC Configuration Studio replaces the functionality of "Tag Export/Import"
To export tags from a WinCC project or import them into a WinCC project, use the WinCC
Configuration Studio.
Information on the Dynamic Wizard Editor
Opening the Dynamic Wizard Editor
The Dynamic Wizard Editor and the Graphics Designer should not be opened at the same
time.
Information on the Tag Simulator
General information
The update time for tag values is one second. Any change will only become active when you
are activating the functions.
A maximum of 300 tags can be configured.
2.3.5 Process communication
Information on the WinCC "SIMATIC S7 Protocol Suite" channel
Time change on an S7 automation system when using AR_SEND
Archive
data transferred from the S7-AS to WinCC with AR_SEND is ignored if the time is reset
on the AS, e.g. following time synchronization. The archive already contains the reset time
period.
Information on the WinCC "SIMATIC S5 PROFIBUS DP" channel
PROFIBUS DP and SIMATIC Net V14
In order to use the "PROFIBUS DP" channel with SIMATIC Net V14, you must disable the
"OPC UA" property for the "DP" protocol in the communication settings of SIMATIC Net V14.
WinCC Release Notes
2.3 Notes on WinCC
WinCC: General information and installation
System Manual, 02/2017, A5E40840020-AA 77

Siemens SIMATIC HMI series Specifications

General

Series	SIMATIC HMI
Category	Control Panel
Display Type	TFT LCD
Touch Screen	Yes (resistive or capacitive, depending on model)
Processor	Varies by model (e.g., ARM-based processors)
Storage	Varies by model (e.g., Flash memory, microSD card slot)
Communication Interfaces	Ethernet, USB
Protection Class	IP65 (front panel), depending on model
Operating Temperature	0 to 50°C, -20 to 60°C
Power Supply	24 V DC
Memory	128 MB, 256 MB