EasyManuals Logo

Siemens SIMATIC HMI series System Manual

Siemens SIMATIC HMI series
226 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #115 background imageLoading...
Page #115 background image
Service and Support
4
4.1 Warnings
Safety information
Warning notice system
This
manual
contains notices you must observe to ensure your personal safety and to prevent
damage to property. Notices referring to your personal safety are highlighted in the manual by
a safety alert symbol; notices referring to property damage only have no safety alert symbol.
The warning notices shown below are graded according to the degree of danger.
DANGER
indicates that death or severe personal injury will result if proper precautions are not taken.
WARNING
indicates that death or severe personal injury may result if proper precautions are not taken.
CAUTION
indicates that minor personal injury may result if proper precautions are not taken.
NOTICE
indicates that property damage may result if proper precautions are not taken.
Note
indicates important information about the product and its use or a specific section of the
documentation to which you should pay particular attention.
If more than one degree of danger is present, the warning notice representing the highest
degree of
danger will be used. A warning notice of injury to persons with a safety alert symbol
may also include a warning relating to property damage.
Qualified personnel
The product/system described in this documentation may be operated only by personnel
qualified for the specific task in accordance with the relevant documentation, in particular its
warning notices and safety information. Qualified personnel are those who, based on their
training and experience, are capable of identifying risks and avoiding potential hazards when
working with these products/systems.
WinCC: General information and installation
System Manual, 02/2017, A5E40840020-AA 115

Table of Contents

Other manuals for Siemens SIMATIC HMI series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMATIC HMI series and is the answer not in the manual?

Siemens SIMATIC HMI series Specifications

General IconGeneral
SeriesSIMATIC HMI
CategoryControl Panel
Display TypeTFT LCD
Touch ScreenYes (resistive or capacitive, depending on model)
ProcessorVaries by model (e.g., ARM-based processors)
StorageVaries by model (e.g., Flash memory, microSD card slot)
Communication InterfacesEthernet, USB
Protection ClassIP65 (front panel), depending on model
Operating Temperature0 to 50°C, -20 to 60°C
Power Supply24 V DC
Memory128 MB, 256 MB

Related product manuals