Siemens SIMATIC HMI series System Manual

Licensing
7
7.1 Software Has a Value
Usage Authorization
With the purchase of the WinCC software you obtain an unrestricted right to usage of the
software. You are entitled to our warranty, our support and service.
The
software
is protected against unlawful use. The programs protected in such a manner can
run only in an unrestricted manner when a valid license for the software package has been
transferred to the hard disk of the corresponding computer.
Each installed software requires a valid license for unrestricted operation. Without a valid
license, WinCC software can only be used in Demo mode.
See also
Basic license types and license types in WinCC (Page 198)
Overview of the licensing (Page 194)
WinCC: General information and installation
System Manual, 02/2017, A5E40840020-AA 193

Siemens SIMATIC HMI series Specifications

General

Series	SIMATIC HMI
Category	Control Panel
Display Type	TFT LCD
Touch Screen	Yes (resistive or capacitive, depending on model)
Processor	Varies by model (e.g., ARM-based processors)
Storage	Varies by model (e.g., Flash memory, microSD card slot)
Communication Interfaces	Ethernet, USB
Protection Class	IP65 (front panel), depending on model
Operating Temperature	0 to 50°C, -20 to 60°C
Power Supply	24 V DC
Memory	128 MB, 256 MB