Virtualization
The following virtualization systems are tested:
● Microsoft Hyper-V 2012 R2 / 2016
●
VMware ESXi 6.0 / 6.5
Requirement
The performance data of the virtual computers must meet the minimum requirements for
WinCC clients.
You can find additional information about virtual environments with WinCC at the following
URL (entry ID=49368181):
● Internet: FAQ Virtualization (
http://support.automation.siemens.com/WW/view/en/
49368181)
See also
Defining Access Rights in the Operating System (Page 28)
Notes about Running the Software
(Page 52)
Notes on Data and System Security (Page 26)
Software Requirements for the Installation (Page 19)
Scope of delivery (Page 8)
1.6.3 Software Requirements for the Installation
Introduction
Certain requirements concerning operating system and software configuration must be met
for the installation.
Note
WinCC is enabled for operation within a domain or workgroup.
Note however that domain group policies and restrictions in the domains may prevent
installation. In this case, remove the computer from the domain before installing Microsoft
Message Queuing, Microsoft SQL Server and WinCC. Log on to the computer concerned
locally with
administrator rights. Carry out the installation. Following successful installation, the
WinCC computer can be registered in the domain again. If the domain-group policies and
domain restrictions do not impair the installation, the computer must not be removed from the
domain during installation.
Note however that domain group policies and restrictions in the domain may also hinder
operation. If these restrictions cannot be overcome, operate the WinCC computer in a work
group. If necessary, contact the domain administrator.
WinCC Installation Notes
1.6 Installation Requirements
WinCC: General information and installation
System Manual, 02/2017, A5E40840020-AA 19
To Next Page
Loading...
Need help?
General
