Siemens SIMATIC HMI series System Manual

The components already installed are displayed during setup. The following icons are used:
Icon Meaning
Current version of program is installed.
Program is being updated.
Program setup conditions are not met. Click the symbol for more detailed information.
Program can be selected.
Program selected for installation.
Program cannot be selected (due to dependence on other programs).
Program selected for installation (cannot be deselected).
Scope of Installation
During custom installation of WinCC, you can choose between the following variants:
Typical
● WinCC Runtime
● WinCC CS
●
Basic Process Control
● SQL Server
Complete "Typical", including:
● OPC servers
●
SmartTools
Expert mode Custom installation:
You can select or deselect individual components in "WinCC Expert".
File server
● WinCC Fileserver
●
SQL Server
WinCC client
1)
●
WinCC Runtime
● WinCC CS
●
Basic Process Control
● SQL Express
1) If you are installing the "WinCC Client", you need an "RT Client" or "RC Client" client license.
You can also install or remove components and languages at a later time. Read the sections
"How to perform a supplementary installation" and "How to perform a supplementary
installation of languages" for more on this.
The required drive space depends upon the installed components. An estimated value is
shown in the status bar.
WinCC Installation Notes
1.7 Installing WinCC
WinCC: General information and installation
System Manual, 02/2017, A5E40840020-AA 37

Siemens SIMATIC HMI series Specifications

General

Series	SIMATIC HMI
Category	Control Panel
Display Type	TFT LCD
Touch Screen	Yes (resistive or capacitive, depending on model)
Processor	Varies by model (e.g., ARM-based processors)
Storage	Varies by model (e.g., Flash memory, microSD card slot)
Communication Interfaces	Ethernet, USB
Protection Class	IP65 (front panel), depending on model
Operating Temperature	0 to 50°C, -20 to 60°C
Power Supply	24 V DC
Memory	128 MB, 256 MB