Siemens SIMATIC TIM 3V-IE DNP3 - Page 182

The SINAUT Configuration Tool
6.6 TD7onTIM
TIM DNP3
182 System Manual, 12/2015, C79000-G8976-C253-04
Data object
Object type and function
Number of
indexes
occupied
DNP3 object group [vari-
ation]
(S7 data type)
DNP3 level *
Use in stations
type **
Dat12D_R
Data object for receive direction
Receive max. 12 double words
(at least 1 double word) with
any information
1 ... 12
• 30 [1] (DINT)
• 30 [5] (REAL)
• 32 [1] (DINT)
• 32 [3] (DINT)
• 32 [7] (REAL)
• 40 [1] (DINT)
• 40 [3] (REAL)
• 41 [1] (DINT)
• 41 [3] (REAL)
• 1 ... 5
• 5
• 1 ... 3
• 4 ... 5
• 5
• 1 ... 5
• 5
• 1 ... 5
• 5
• M
• M
• M
• M
• M
• S
• S
• S
• S
2 ... 24
• 30 [2] (INT, WORD)
• 32 [2] (INT, WORD)
• 32 [4] (INT, WORD)
• 40 [2] (INT, WORD)
• 41 [2] (INT, WORD)
• 1 ... 5
• 1 ... 3
• 4 ... 5
• 1 ... 5
• 1 ... 5
• M
• M
• M
• S
• S
4 ... 48
• 30 [2] (BYTE)
• 32 [2] (BYTE)
• 32 [4] (BYTE)
• 40 [2] (BYTE)
• 41 [2] (BYTE)
• 110 [1..255] (CHAR)
• 111 [1..255] (CHAR)
• 1 ... 5
• 1 ... 3
• 4 ... 5
• 1 ... 5
• 1 ... 5
• 1 ... 5
• 1 ... 5
• M
• M
• M
• S
• S
• M / S
• M
Objects for data exchange with MODBUS slaves (only in station)
ModbusWrite
Write data from the station
CPU to the MODBUS slave
-
-
ModbusRead
Read data from the MODBUS
slave to the station CPU
-
-
Data objects not supported
Par12x1D_R Cannot be used for the DNP3
protocol
-
-
*
DNP3 implementation level that must be supported by the communications partner.
**
Station type: M = master station TIM, S = station TIM
***
These objects are used to mirror back values from the station to the master station, see the following reference.
****
The following objects are always sent by the master TIM with the control code "DIRECT_OPERATE": Bin08X_S (12),
Cmd01B_S (12), Par12D_S (41), Set01W_S (41)
Mirroring back: You will find an description of the function in the section in the section
Mirroring back (Page 183).
You will find a table sorted according to DNP3 object groups in the section Supported DNP3
object groups (Page 162).