Diagnostics and upkeep
7.3 SINAUT diagnostics and service tool
TIM DNP3
290 System Manual, 12/2015, C79000-G8976-C253-04
0663
Entering state: Error occurred receiving a message.
F460 Exiting state: Error occurred receiving a message.
0664
Entering state: Heap memory overflow.
Exiting state: Heap memory overflow eliminated.
0665
Entering state: Unknown PDU received.
Exiting state: Unknown PDU received.
Incorrect firmware version installed on TIM.
0667
Entering state: All [n] LAN connections are disrupted.
Exiting state: [x] of [n] LAN connections are OK.
Message buffer of TIM records was deleted.
0669
Entering state: DNP3 Message Monitor
Exiting state: DNP3 Message Monitor off
066A
Entering state: Extended diagnostics on
Exiting state: Extended diagnostics off
Extended diagnostics - modification
Error occurred in system status list query.
Messages from P bus server
Installation of P bus server aborted.
Unknown message received from task.
F560 06B2 Error occurred receiving a message.
06B3
Entering state: Power outage on P bus.
Exiting state: Power supply on P bus OK.
06B4
Entering state: I/O disabled by CPU.
Exiting state: I/O enabled by CPU.
Module on P bus not capable of communication.
Parity error in P bus communication.
Bit shift error in P bus communication.
Diagnostic interrupt cannot be sent. Module is not enabled on P bus.
Diagnostic interrupt cannot be sent. Diagnostic interrupt is not enabled on P bus.
SDB0 cannot be opened. File overwritten without comparison.
BUS3-ASIC could not be initialized.
SDB5 cannot be opened. File overwritten without comparison.
Messages from the SDB handler
Installation of the SDB handler aborted.
To Next Page
Loading...
Need help?
General
