Diagnostics and upkeep
7.3 SINAUT diagnostics and service tool
TIM DNP3
System Manual, 12/2015, C79000-G8976-C253-04
291
SDB could not be deleted.
F560 06E3 SDB could not be loaded.
SDB information of hierarchy 1 not available.
SDB information of hierarchy 2 not available.
SDB information of hierarchy 3 not available.
SDB handler: Unknown job.
Control instruction unknown.
Error occurred during firmware update.
0700
Entering state: TD7 installation started.
Exiting state: TD7 installation ready.
SecIntervall task was not started.
TD7_ObjectAdmin task was not started.
The path for SDB files could not be opened.
The TD7 SDB could not be found.
The TD7 SDB could not be opened.
Header with incorrect length of block ID.
F560 0709 TD7-SDB: No TD7 parameters found.
TD7-SDB: Block not found.
TD7-SDB: T4T_MAINHDR has incorrect length.
TD7-SDB: T4T_SUBDATA has incorrect length.
TD7-SDB: Unknown format in a destination subscriber block.
TD7-SDB: Number of partner blocks incorrect.
TD7-SDB: Unknown format in a partner block.
TD7-SDB: Unknown channel type.
TD7-Run: Not enough memory for the channel list.
TD7-SDB: Channel block not found.
TD7-Run: Not enough memory for a channel object.
TD7-SDB: The number of data entries is incorrect.
TD7-SDB: The number of object entries is incorrect.
TD7-Par: Subscriber object for a partner not found.
TD7-Par: Unknown partner.
TD7-Par: Invalid scan cycle ID.
TD7-Run: Object not in fast cycle.
TD7-SDB: No objects found in header ID.
TD7-SDB: Unknown format in an object.
TD7-Par: Not enough memory for scan cycle job list.
To Next Page
Loading...
Need help?
General
