Approvals
TIM DNP3
308 System Manual, 12/2015, C79000-G8976-C253-04
The device meets the requirements of explosion protection according to IECEx.
IECEx classification: Ex nA IIC T4 Gc
IECEx certificate: IECEx DEK 14.0086X
The device meets the requirements of the following standards:
● IEC 60079-0
Hazardous areas - Part 0: Equipment - General requirements
● IEC 60079-15
Explosive atmospheres - Part 15: Equipment protection by type of protection 'n'
You can see the current versions of the standards in the IECEx certificate that you will find
on the Internet at the following address:
Link: (https://support.industry.siemens.com/cs/ww/en/view/109475158)
The conditions must be met for the safe deployment of the product according to the section
Notices on use in hazardous areas according to ATEX / IECEx (Page 65).
You should also note the information in the document "Use of subassemblies/modules in a
Zone 2 Hazardous Area" that you will find on the Internet at the following address:
Link: (https://support.industry.siemens.com/cs/ww/en/view/78381013)
The device meets the requirements of the EC directive 94/9/EC "Equipment and Protective
Devices for Use in Potentially Explosive Atmospheres".
Applied standards:
● EN 60079-0
Hazardous areas - Part 0: Equipment - General requirements
● EN 60079-15
Explosive atmospheres - Part 15: Equipment protection by type of protection 'n'
The current versions of the standards can be seen in the EC Declaration of Conformity, see
above.
ATEX approval: II 3 G Ex nA IIC T4 Gc
Test number: KEMA 03 ATEX1228 X
The conditions must be met for the safe deployment of the device according to the section
Notices on use in hazardous areas according to ATEX / IECEx (Page 65).
You should also note the information in the document "Use of subassemblies/modules in a
Zone 2 Hazardous Area" that you will find on the Internet at the following address:
Link: (https://support.industry.siemens.com/cs/ww/en/view/78381013)
To Next Page
Loading...
Need help?
General
