Siemens SIMOCODE pro User Manual

Description of the blocks
4.3 MMOprtn block
SIMOCODE pro PCS 7 Library V9.0
148 Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
4.3.23
Faceplate views
4.3.23.1
MMOprtn - Standard
Standard view
①
Display of the control function
②
Button for changing the operating mode (AutoModOp, ManModOp, LocalOp, OosOp); opens
the expanded command range
③
Buttons
• for emergency start
• for testing
• for resetting the trip (TrpRstOp)
The buttons open the expanded command area; authorization level 5 and higher.
④
Button for switching to the standard view of a faceplate for representing the logbook values
(MMLog); visible if the Selfp1 input parameter of the MMOprtn block is configured.
⑤
Button for switching to the standard view of a faceplate for representing the statistical values
(MMStat); visible if the Selfp2 input parameter of the MMOprtn block is configured.
⑥
Button for switching to the standard view of a faceplate for representing the measured values
(MMMeas); visible if the Selfp1 input parameter of the MMOprtn block is configured.
⑦
Status displays of the block:
• Test position
• Invalid signal
• Rack fault
• Group error

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000