Siemens SIMOCODE pro User Manual

Description of the blocks
4.1 Functions for all blocks
SIMOCODE pro PCS 7 Library V9.0
Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
87
4.1.10.17
Bumpless switchover to automatic mode
Number of the Feature bit: 21
Feature bit purpose
Specify whether bumpless switchover to automatic mode for valves, motors and dosing unit
can be enabled only if switching via the faceplate is in effect, or whether switching using
interconnectable inputs
AutModLi and ManModLi (ModLiOp =1) is also possible.
The default setting is 0.
Bit = 0:
The function "Bumpless switchover to automatic mode for valves, motors and
dosers" works when switching via the faceplate and switching using interconnectable inputs
AutModLi and ManModLi (ModLiOp = 1).
Bit = 1:
The "Bumpless switchover in automatic mode for valves, motors and dosers"
function only works for switching via the faceplate. Bumping switchover can be activated via
the inputs
AutModLi and ManModLi (ModLiOp = 1).
4.1.10.18
Update acknowledgement and error status of the alarm
Number of the Feature bit: 22
Feature bit purpose
To determine if the acknowledgement and error status of the message call at the block
output should be updated.
The default setting is 0.
Bit = 0:
The MsgErr, MsgStat and MsgAckn block outputs are set to the default settings and not
updated. The block will run faster with this setting.
Bit = 1:
The MsgErr, MsgStat and MsgAckn block outputs are updated based on the feedback
from the lower level message blocks. The lower level message blocks are called every other
cycle as long as an acknowledgement is expected or error information is pending.
4.1.10.19
Activate local operator permission
Number of the Feature bit: 24
Feature bit purpose
To enable local permission for a technologic block.
The default setting is 0.
Bit = 0:
Disabled
Bit = 1:
Enabled.

Siemens SIMOCODE pro Specifications

General

Brand	Siemens
Model	SIMOCODE pro
Category	Control Unit
Language	English