Introduction
1.8 Parameterization softwares
SIMOCODE pro PCS 7 Library V9.0
32 Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
Parameterization softwares
1.8.1
Parameterization Softwares
Parameterization Softwares
For parametrizing the device following softwares are availible:
- SIMOCODE ES (with OM intergration)
- SIMATIC PDM (with EDD)
- GSD
Configuring in SIMOCODE ES
Purpose of the SIMOCODE ES software
SIMOCODE ES is used to configure SIMOCODE pro devices.
Note
Transmission of modified device parameters is possible under the following conditions:
The device is
in the SIMOCODE pro "remote" mode.
No ON control command is active.
No motor current is flowing.
Note
Some device parameters can be modified independently of the conditions named above.
You can recognize these parameters by the blue motor symbol in front of the parameter.
To Next Page
Loading...
Need help?
General
