Siemens SIMOCODE pro User Manual

Description of the blocks
4.7 MMRevDhl motor block
SIMOCODE pro PCS 7 Library V9.0
Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
217
The operator permissions control operation only in the faceplate.
Table 4- 103 Operator permissions – MMRevDhl
OS_Perm
bit
OS_PermOut
bit
OS_PermLog
bit
Description
0 0 0 1 = Operator is permitted to change to AUTO
mode.
1 1 1 1 = Operator is permitted to change to
MANUAL mode.
2 2 2 1 = Operator is permitted to change to Local
mode.
3 3 3 1 = Operator is permitted to change to "Out of
service" mode
4 4 4 1 = Operator is permitted to stop the motor
5 5 5 1 = Operator is permitted to start the motor
(forward) On>
6 6 6 1 = Operator is permitted to start the motor
(reverse) On>
7 7 7 1 = Operator is permitted to start the motor
(fast forward) On>>
8 8 8 1 = Operator is permitted to start the motor
(fast reverse) On<<
9 9 9 1 = Operator is permitted to reset the motor
10 10 10 1 = Operator is permitted to define the
monitoring time for startup
11 11 11 1 = Operator is permitted to define the
monitoring time for runtime
12 12 12 1 = Operator is permitted to activate the
monitoring time function (Bit10, Bit11)
13 13 13 1 = Operator is permitted to activate the
Simulation function
14 14 14 1 = Operator is permitted to activate the
maintenance release function
15...25 15...25 15...25 Reserved
26 26 26 1 = Operator can change the simulation value
SimAV
27...29 27...29 27...29 Reserved
30 30 30 1 = Operator can define the monitoring time
for control stop
31 31 31 1 = Operator can execute the rapid stop

Siemens SIMOCODE pro Specifications

General

Brand	Siemens
Model	SIMOCODE pro
Category	Control Unit
Language	English