5
05.01
5.1 Closed–loop control with digital setpoint interface
5-105
© Siemens AG 2008 All Rights Reserved
SIMODRIVE 611 Configuration Manual (PJU) – 05/2008 Edition
1–axis version
High Performance
2–axis version
High Performance/High Standard
0.5 Nm
0.5 Nm
M3/0.8 Nm
M3/0.8 Nm
DAC 1 DAC 2
DAC 3 Ground
DAC assignment
DAC 1 DAC 2
DAC 3 Ground
DAC assignment
M3/0.8 Nm
Fig. 5-1 Digital control High Performance and High Standard with direct measuring system
Notice
When using non–PELV circuits at terminals AS1, AS2, connectors must be
coded to prevent the connectors being incorrectly inserted (refer to
EN60204–1, Section 6.4).
For Order No. for coded connectors, refer to Catalog NC 60.
5 Control Units11.05
To Next Page
Loading...
