5
05.01
5.2 ”SIMODRIVE 611 universal HRS” control board
5-116
© Siemens AG 2008 All Rights Reserved
SIMODRIVE 611 Configuration Manual (PJU) – 05/2008 Edition
The ”SIMODRIVE 611 universal” control board can be connected and operated
as DP slave on the PROFIBUS DP fieldbus when this optional module is used.
X423
Two–color LED
for diagnostics
For screws:
Tighten (due to the shield contact)
max. torque = 0.8 Nm
Fig. 5-7 Optional PROFIBUS DP module
Table 5-8 Which optional modules are available?
Designation Order No. (MLFB) Properties
PROFIBUS DP2 6SN1114–0NB00–0AA2
S PROFIBUS ASIC DPC31 without PLL
S For control boards as of SW 3.1, this module can replace the
optional PROFIBUS DP1 module
Features that
PROFIBUS DP2 and DP3 have in common
S Requirement:
Control board as of SW 3.1 is required
S Cyclic data transfer (PKW and PZD section) possible
S FW module can be updated using SimoCom U
S Non–cyclic data transfer (DP/V1)
S ”SimoCom U via PROFIBUS” possible
PROFIBUS DP3 6SN1114–0NB01–0AA1
S PROFIBUS ASIC DPC31 with PLL
S ”Motion Control with PROFIBUS DP” function (clock–synchro-
nous PROFIBUS operation) is possible
Optional
PROFIBUS DP
module
5 Control Units 11.05
To Next Page
Loading...
