5
05.01
5.2 ”SIMODRIVE 611 universal HRS” control board
5-117
© Siemens AG 2008 All Rights Reserved
SIMODRIVE 611 Configuration Manual (PJU) – 05/2008 Edition
Table 5-9 Which optional modules can be used for the various software releases?
Case Firmware version Optional module
DP2 DP3
1. A master configured software, generated with GSD file
siem808f.gsd, can be operated with
as of SW 3.1 Yes Yes
2. A master configured software, generated with a GSD file
siem8055f.gsd and P0875 = 2, can be operated with
before SW 4.1 Yes Yes
3. A master configured software, generated with a GSD file
siem8055f.gsd and P0875 = 2, can be operated with
as of SW 4.1 Yes Yes
4. Master configured application, generated with a GSD file
si02808f.gsd and P0875 = 2 can be operated with
as of SW 6.1 Yes Yes
Note
Case 1 is for ”new” applications with the DP2, DP3 module.
Cases 2 and 3 are for series commissioning of drives using DP1 modules and
for replacing a defective DP1 module by a DP2 module.
5 Control Units11.05
To Next Page
Loading...
