5
05.01
5.2 ”SIMODRIVE 611 universal HRS” control board
5-123
© Siemens AG 2008 All Rights Reserved
SIMODRIVE 611 Configuration Manual (PJU) – 05/2008 Edition
S Resolvers
Table 5-13 Encoder signal input of motor encoder X411, X412 (resolver)
Pin X411 (axis 1)
X412 (axis 2)
Function
1 – Reserved, do not use
2 M Ground
3 AP Resolver, sinusoidal
4 AN Resolver, sinusoidal, inverted
5 M Inner shield ground
6 BP Resolver, cosine
7 BN Resolver, cosines, inverted
8 M Inner shield ground
9 EXC_POS Resolver excitation (pos.)
10 – Reserved for test purposes, do not use
11 EXC_NEG Resolver excitation (neg.)
12 – Reserved for test purposes, do not use
13 THMOTP KTY 84 (+) temperature sensor
14 – Reserved, do not use
15 – Reserved for test purposes, do not use
16 – Reserved, do not use
17 – Reserved, do not use
18 – Reserved, do not use
19 – Reserved, do not use
20 – Reserved, do not use
21 – Reserved, do not use
22 – Reserved, do not use
23 – Reserved, do not use
24 M Inner shield ground
25 THMOTCOM KTY 84 (–) temperature sensor
Note:
The inputs on the control must not be assigned any signals other than the intended sig-
nals. Otherwise, sporadic or permanent malfunctions can occur.
5 Control Units02.07
To Next Page
Loading...
