5
05.01
5.3 ”SIMODRIVE 611 universal E HRS” control board
5-125
© Siemens AG 2008 All Rights Reserved
SIMODRIVE 611 Configuration Manual (PJU) – 05/2008 Edition
5.3.1 Control board with optional module
Mounting slot
for the optional
PROFIBUS DP3 module
Memory module
S Firmware
S User data
Pulse interface
The following applies to retaining
screws:
Tighten (due to the shield contact)
max. torque = 0.8 Nm
”SIMODRIVE 611 universal E HRS” control board
2 axis for encoders with sin/cos 1Vpp
Equipment bus
Display and
operator unit
S Interfaces
S Terminals
S Measuring sockets
Serial interface
(RS232)
Optional
PROFIBUS DP3 module
with PROFIBUS ASIC
DPC31 with PLL
Encoder interface for
TTL encoders
For plug connections:
Plug connectors with the same number of
pins must be appropriately coded so that
they cannot be interchanged (refer to the
index entry ”Coding the mini connectors”).
X302
Fig. 5-8 ”SIMODRIVE 611 universal E HRS” control board with optional PROFIBUS DP3 module
Control board
with optional
PROFIBUS DP
module
5 Control Units11.05
To Next Page
Loading...
