05.01
v
© Siemens AG 2008 All Rights Reserved
SIMODRIVE 611 Configuration Manual (PJU) – 05/2008 Edition
Setup and operation of the device/equipment/system in question must only be
performed using this documentation. Commissioning and operation of a device/
system may only be performed by qualified personnel. Qualified personnel as
referred to in the safety instructions in this documentation are persons autho-
rized to start up, ground, and label devices, systems, and circuits in accordance
with the relevant safety standards.
This Configuration Manual provides all of the detailed information required to
use and handle SIMODRIVE components.
Should you wish for additional information or should exceptional problems arise
that are not addressed in sufficient detail in this manual, you can request the
required information from your local Siemens office.
The following should be observed when using this manual:
1. Help: The following help is available for the reader:
S Complete table of contents
S Header line (as orientation):
the main chapter is in the upper header line
the sub–chapter is in the lower header line
S Appendix with
– Abbreviations and List of References
– Index
If you require information regarding a specific term, then look for this in
the Appendix under the Chapter ”Index”.
The Chapter number as well as the page number is specified where in-
formation on this term can be found.
2. Edition of the documentation:
The history of the document editions is summarized in the printing history.
The header of the document indicates the current edition (12/2006).
Reader’s note
Only the digital components for a SIMODRIVE group with High Performance/
High Standard and 611 universal modules are described in Edition A10.04 and
higher. Please refer to the overview in Chapter 5.1 regarding from which
software releases, use is possible.
The descriptions for the relevant controls in the Configuration Manual, Edition
02.03, still remain valid for the analog components that have been discontinued
(not for new configurations)!
This documentation contains information that must be observed to ensure your
personal safety and to prevent material damage. The instructions for your per-
sonal safety are marked by a warning triangle. Instructions relating solely to
material damage are not marked by a warning triangle. The warnings appear in
decreasing order of risk as given below.
Definition:
Who are qualified
personnel?
Objectives
Information for
using this Manual
Safety information
Forword12.0602.0711.05
To Next Page
Loading...
