Siemens SIMODRIVE 611 universal - Page 129

4
01.99
4.4 Commissioning using the display and operator unit
4-129
 Siemens AG 2005 All Rights Reserved
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
yes
Adapt the necessary system–specific parameters as
required (e.g. the input/output terminals, monitoring
functions, optimization)
Values
changed?
no
yes
Remove write protection (P0651 = 4)
1
2
”_ _ _ run”
is displayed
(cyclic operation)
no
End
(cyclic operation)
continue on the next
page
from the previous page
Write into the FEPROM (P0652 = 1)
and wait until writing has been completed (P0652 = 0)
Save the parameters in the FEPROM
Is an unlisted
motor being
used?
Unlisted motor:
(refer under the index entry
”Unlisted motor – what is
one”)
Fig. 4-4 Commissioning using the display and operator unit (Part 2 of 3)
4 Commissioning