Siemens SIMODRIVE 611 universal - General Information on Motor Changeover; Motor Changeover for Induction Motors (from SW 2.4)

6
6.11 Motor changeover for induction motors (from SW 2.4)
6-580
 Siemens AG 2005 All Rights Reserved
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
6.11 Motor changeover for induction motors (from SW 2.4)
6.11.1 General information on motor changeover
The following changeover functions can be implemented depending on
the setting in P1013 (motor changeover):
Table 6-60 Motor changeover versions
P1013
changeover Description Refer-
ence
0 none
Properties:
Motor data set 1 (P1xxx) is always selected.
–
Max. 4 motors,
each with
1 motor data set
Features:
 The motor/motor data sets are changed over us-
ing freely–parameterizable input/output terminals.
1
5
6
11
14
P1xxx
M
P2xxx
M
P3xxx
M
P4xxx
M
Fct. No.
Outputinput
ing freely–parameterizable input/output terminals.
 The pulses are canceled at each changeover
operation.
Application:
 Changing over several motors
1)2)
Refer to
Chapter
6.11.2
1 motor with max.
4 motor data sets
Features:
 The motor data sets are changed over using
freely–parameterizable input terminals.
2
P1xxx
M
P2xxx
P3xxx
P4xxx
5
6
input
Fct. No.
The motor data sets are changed over using
freely–parameterizable input terminals.
 The pulses are not canceled when changing over
.
Application:
 Adaptation of the motor and controller data (e.g.
pulse frequency changeover)
Refer to
Chapter
6.11.3
Max. 2 motors each with
2 motor data sets
Features:
 The motors/motor data sets are changed over via
a freely parameterizable input terminal and via the
speed thresholds.
If an input terminal is used to change over, the
3
n
n
P1xxx
M
P2xxx
P3xxx
M
P4xxx
6
11
13
input Output
Fct. No.
 If an input terminal is used to change over, the
pulses are canceled.
 The pulses are not canceled if changeover is real
-
ized using speed thresholds.
Application:
 Speed–dependent adaptation of the motor and
controller data (e.g. pulse frequency changeover)
for
– one motor
– two motors
– star/delta operation
Refer to
Chapter
6.11.4
1) Encoder changeover is not possible.
2) Only 1 motor can be used with encoder.
Versions for
motor changeover
6 Description of the Functions
01.99
04.99
! not 611ue !