4.8 Permanent–magnet synchronous motor with field–weakening (PE spindle)
4-154
Siemens AG 2005 All Rights Reserved
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
A motor spindle generally consists of the following components:
Spindle box
Spindle with bearings
Cooling system
The spindle manufacturer is responsible for designing the bearings,
lubrication and cooling.
Build–in motor
– 4–pole series (especially suitable for high speeds)
– 6–pole series (especially suitable for high torque)
– A VP module (VPM) is required, depending on the EMF (rotor
voltage) (VPM: Voltage Protection Module)
– Maximum speed: up to 16 000 RPM
Maximum torque: up to 310 Nm
(depending on the frame size)
Encoder system (integrated encoder)
– Hollow shaft measuring systems with sin/cos 1 Vpp
(e.g. SIZAG 2 or SIMAG H)
The prerequisites are as follows:
Control board
SIMODRIVE 611 universal for encoders with sin/cos 1Vpp
Maximum motor cable length = 50 m
Motor
spindle
components
System
prerequisites
10.99
To Next Page
Loading...
