Siemens SIMODRIVE 611 universal - Page 551

6
6.7 Analog outputs
6-551
 Siemens AG 2005 All Rights Reserved
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
Table 6-56 Signal selection list for analog outputs, continued
Signal Normaliza-
tion
(corre-
sponds
to LSB)
UnitsBit
width
Shift
fac-
tor
Displayed
in
Operating
mode
No.
Normaliza-
tion
(corre-
sponds
to LSB)
UnitsBit
width
Shift
fac-
tor
Displayed
in
posn–setDesignation
522
3)
PROFIBUS encoder 2 posi-
tion actual value 1
(G2_XIST1) (from SW 7.1)
x – P1789:x
1)
8 32 – –
523
3)
PROFIBUS encoder 2 posi-
tion actual value 2
(G2_XIST2) (from SW 7.1)
x – P1789:x
1)
8 32 – –
524
3)
PROFIBUS encoder 3 posi-
tion actual value 1
(G3_XIST1) (from SW 7.1)
x – P1789:x
1)
8 32 – –
525
3)
PROFIBUS encoder 3 posi-
tion actual value 2
(G3_XIST2) (from SW 7.1)
x – P1789:x
1)
8 32 – –
Note:
 Abbreviations
– rms: rms value
– pk: Peak value
– LSB: Least significant bit
– MSR: Dimension system grid
 Signal marking?
– Not marked: For SimoCom U, the signal is available as standard
– Marked in gray: For SimoCom U, the signal is only available when the expert mode is activated
1) Dependent on the assignment in P0915:17
2) Dependent on the assignment in P0916:17
3) PROFIBUS signal only supplies a value if it is set in P0615 or P0916.
4) This only applies for spindle positioning
6 Description of the Functions
01.99
04.9906.04