Siemens SINAMICS GM150 - Page 8

5.10 Removing the dust protection cover.......................................................................................94
5.10.1 Tools required........................................................................................................................94
5.10.2 Removing the dust protection cover of the closed-loop control cabinet.................................95
5.10.3 Removing the dust protection cover of the inverter cabinet...................................................96
5.10.4 Removing the dust protection cover of the rectifier cabinet...................................................97
5.11 Installing the battery of the uninterruptible power supply.......................................................99
6 Electrical connection.................................................................................................................................101
6.1 Safety instructions for electrical connections.......................................................................101
6.2 Electromagnetic compatibility...............................................................................................103
6.3 Potential concept..................................................................................................................106
6.4 Electrical requirements.........................................................................................................107
6.5 Connection...........................................................................................................................107
6.5.1 Manually unlocking power-unit doors...................................................................................107
6.5.2 Preparations for connecting the power cables.....................................................................108
6.5.3 Connecting power cables.....................................................................................................108
6.5.4 Connect the power cable to the motor and the supply system............................................109
6.5.5 Connecting ground...............................................................................................................111
6.5.6 Connect the auxiliary voltage...............................................................................................111
6.5.7 Connecting the control cables to the circuit-breaker for the capacitor release (option N20)....112
6.5.8 Connecting the encoder to the SMC30 Sensor Module.......................................................113
6.5.9 Interconnecting optional connections...................................................................................115
6.5.10 Connecting the re-cooling unit to the drive...........................................................................115
6.5.11 Fastening the cable ducts with cable ties.............................................................................116
7 Start-up ....................................................................................................................................................117
7.1 Venting the converter...........................................................................................................117
7.2 Description and configuration of the PROFIBUS interface..................................................119
7.2.1 Hardware components required for PROFIBUS communication ........................................119
7.2.2 PROFIBUS interface, diagnostics LEDs, address switches.................................................120
7.2.3 Connecting PROFIBUS cables............................................................................................122
7.2.4 Setting the PROFIBUS address switches............................................................................123
7.2.5 Requirements for communication via PROFIBUS...............................................................124
8 Operation..................................................................................................................................................125
8.1 Safety instructions for operation...........................................................................................125
8.2 Operation via the AOP30 operator panel.............................................................................126
8.2.1 General information about the AOP30 operator panel.........................................................126
8.2.1.1 AOP30 operator panel.........................................................................................................126
8.2.1.2 Buttons of the AOP30..........................................................................................................128
8.2.1.3 Basic operation of the AOP 30.............................................................................................128
8.2.2 Configuration of the AOP30 operator panel.........................................................................131
8.2.2.1 Define operation screen.......................................................................................................131
8.2.2.2 Control settings....................................................................................................................135
8.2.2.3 Inhibit functions....................................................................................................................138
8.2.3 Menu description and setting options...................................................................................141
8.2.3.1 Operation screen..................................................................................................................141
8.2.3.2 Parameterization..................................................................................................................143
Table of contents
SINAMICS GM150 6SL3815-2LN41-4AA2
8 Operating Instructions 04/2017