Siemens SINAMICS S120 - Function Diagrams and Parameters

Vector control
5.22 Bypass
Drive functions
292 Function Manual, 11/2017, 6SL3097-4AB00-0BP5
5.22.5
Function diagrams and parameters
Function diagrams (see SINAMICS S120/S150 List Manual)
•
7020
Technology functions
- Synchronizing
Overview of important parameters (see SINAMICS S120/S150 List Manual)
Bypass function
•
p1260
Bypass configuration
•
r1261.0...12
CO/BO: Bypass control/status word
•
p1262[0...n]
Bypass dead time
•
p1263
Debypass (revert to drive) delay time
•
p1264
Bypass delay time
•
p1265
Bypass speed threshold
•
p1266
BI: Bypass control command
•
p1267
Bypass changeover source configuration
•
p1268
BI: Bypass feedback signal synchronization completed
•
p1269[0...1]
BI: Bypass switch feedback signal
Synchronization
•
p3800[0...n]
Sync
-line-drive activation
•
p3801[0...n]
Sync
-line-drive drive object number
•
p3802[0...n]
BI: Sync
-line-drive enable
•
r3803.0
CO/BO: Sync
-line-drive control word
•
r3804
CO: Sync
-line-drive target frequency
•
r3805
CO: Sync
-line-drive frequency difference
•
p3806[0...n]
Sync
-line-drive frequency difference threshold value
•
r3808
CO: Sync
-line-drive phase difference
•
p3809[0...n]
Sync network drive phase setpoint value
•
p3811[0...n]
Sync
-line-drive frequency limitation
•
r3812
CO: Sync
-line-drive correction frequency
•
p3813[0...n]
Sync
-line-drive phase synchronism threshold value
•
r3814
CO: Sync
-line-drive voltage difference
•
p3815[0...n]
Sync
-line-drive voltage difference threshold value
•
r3819.0...7
CO/BO: Sync
-line-drive status word