Siemens SINAMICS S120 - Page 856

Communication
11.3 Communication via PROFINET IO
Drive functions
856 Function Manual, 11/2017, 6SL3097-4AB00-0BP5
The I&M data sets 1...4 are stored permanently in parameters p8806...p8808. Essential
properties of these 3 parameters:
● They can be displayed in the STARTER expert list.
● The SINAMICS "Reset parameter" (p0976 = 1, p0970 = 1) function does not have any
effect on the content of the parameters.
● I&M data sets are not changed when the alternative parameter sets are stored or loaded.
The transfer of parameter sets between a memory card and non-volatile device memory
does not have any effect on the I&M data sets.
Overview of important parameters (see SINAMICS S120/S150 List Manual)
•
p8806[0...53]
Identification and Maintenance
1
•
p8807[0...15]
Identification and Maintenance
2
•
p8808[0...53]
Identification and Maintenance
3
•
r8809[0...53]
Identification and Maintenance
4