Flexible NC programming
1.25 Subprogram technique
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
171
Example 4: Display response in the case of different DISPLON/DISPLOF combinations
03
ZLWKRXW
352&
63
352&
',63/2)
63
352&
',63/21
63
352&
',63/2)
63
352&
',63/2)
63
352&
',63/21
63
352&
',63/2)
$68%
352&
',63/2)
63
ZLWKRXW
352&
63
ZLWKRXW
352&
3URJUDPOHYHO
030DLQSURJUDP
636XESURJUDP
$68%$V\QFKURQRXVVXESURJUDPLQWHUUXSWURXWLQH
① The part program lines from program level 0 are displayed in the current block display.
② The part program lines from program level 3 are displayed in the current block display.
③ The part program lines from program level 3 are displayed in the current block display.
④ The part program lines from program level 7/8 are displayed in the current block display.
1.25.2.7 Identifying subprograms with preparation (PREPRO)
Function
All files can be identified with the PREPRO keyword at the end of the PROC operation line during
power up.
Note
This type of program preparation depends on the relevant set machine data. Please follow
the manufacturer's instructions.
References:
Function Manual, Special Functions, Preprocessing (V2)
Syntax
PROC … PREPRO
To Next Page
Loading...
