Transformations
6.11 Deselect transformation (TRAFOOF)
Job planning
386 Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
6.11 Deselect transformation (TRAFOOF)
Function
The TRAFOOF command deactivates all active transformations and frames.
Note
Frames required after this must be activated by renewed programming.
Please note:
The same restrictions as for selection are applicable to deselecting the transformation (see
section "Constraints when selecting a transformation").
Syntax
TRAFOOF
Significance
TRAFOOF
Command for deactivating all active transformations/frames
To Next Page
Loading...
