Siemens SINUMERIK 828D

Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
809
Index
$
$AA_ATOL, 492
$AA_COUP_ACT, 457, 500, 525
$AA_LEAD_SP, 525
$AA_LEAD_SV, 525
$AA_MOTEND, 276
$AA_TOFF[ ], 592
$AC_ACT_PROG_NET_TIME, 684
$AC_ACTUAL_PARTS, 687
$AC_BLOCKTYPE, 571
$AC_BLOCKTYPEINFO, 571
$AC_CTOL, 492
$AC_CUT_INV, 449
$AC_CUTMOD, 448
$AC_CUTMOD_ANG, 448
$AC_CUTTING_TIME, 684
$AC_CYCLE_TIME, 683
$AC_FIFO1, 569
$AC_MARKER, 564
$AC_OLD_PROG_NET_TIME, 684
$AC_OLD_PROG_NET_TIME_COUNT, 684
$AC_OPERATING_TIME, 683
$AC_OTOL, 492
$AC_PARAM, 565
$AC_PROG_NET_TIME_TRIGGER, 684
$AC_REQUIRED_PARTS, 687
$AC_SMAXVELO, 488
$AC_SMAXVELO_INFO, 488
$AC_SPECIAL_PARTS, 687
$AC_SPLITBLOCK, 571
$AC_STOLF, 495
$AC_TIMER, 568
$AC_TOTAL_PARTS, 687
$AN_POWERON_TIME, 683
$AN_SETUP_TIME, 683
$MC_COMPESS_VELO_TOL, 463
$P_AD, 449
$P_CTOL, 493
$P_CUT_INV, 449
$P_CUTMOD, 448
$P_CUTMOD_ANG, 448
$P_OTOL, 493
$P_STOLF, 495
$P_SUBPAR, 155
$P_TECCYCLE, 622
$PA_ATOL, 493
$R, 565
$Rn, 565
$SA_LEAD_TYPE, 524, 525
$SC_PA_ACTIV_IMMED, 224
$SN_PA_ACTIV_IMMED, 224
$TC_CARR1...14, 434
$TC_CARR18[m], 434, 438
$TC_DP1, 390
$TC_DP10, 390
$TC_DP11, 390
$TC_DP12, 390
$TC_DP13, 390
$TC_DP14, 390
$TC_DP15, 390
$TC_DP16, 390
$TC_DP17, 390
$TC_DP18, 390
$TC_DP19, 390
$TC_DP2, 390
$TC_DP20, 390
$TC_DP21, 390
$TC_DP22, 390
$TC_DP23, 390
$TC_DP24, 390
$TC_DP25, 390
$TC_DP3, 390
$TC_DP4, 390
$TC_DP5, 390
$TC_DP6, 390
$TC_DP7, 390
$TC_DP8, 390
$TC_DP9, 390
$TC_ECPxy, 394
$TC_SCPxy, 394
$TC_TPG1 ... 9, 659, 660
*
* (arithmetic function), 63
/
/ (arithmetic function), 63
+
+ (arithmetic function), 63