Siemens SINUMERIK 828D - Curve Tables: Determine Table Properties (CTABID, CTABISLOCK, CTABMEMTYP, CTABPERIOD)

Axis couplings
9.2 Curve tables (CTAB)
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
511
Specification of memory location (optional)
In the case of locking/unlocking without a memory location being
specified, the specified curve tables are locked/unlocked in the static
and the dynamic NC memory.
In the case of locking/unlocking with a memory location being
specified, of the specified curve tables, only those located in the
specified memory location are locked/unlocked. The rest are not
locked/unlocked.
"SRAM"
Lock/unlock in the static NC memory
<memory location>
"DRAM"
Lock/unlock in the dynamic NC memory
If
CTABLOCK/CTABUNLOCK is programmed without specification of the curve table to be
locked/unlocked, then all curve tables or all curve tables in the specified memory will be
locked/unlocked:
CTABLOCK()
Locks all curve tables in the static and the dynamic NC
memory
CTABLOCK(,,"SRAM")
Locks all curve tables in the static NC memory
CTABLOCK(,,"DRAM")
Locks all curve tables in the dynamic NC memory
CTABUNLOCK()
Unlocks all curve tables in the static and dynamic NC
memory
CTABUNLOCK(,,"SRAM")
Unlocks all curve tables in the static NC memory
CTABUNLOCK(,,"DRAM")
Unlocks all curve tables in the dynamic NC memory
9.2.5 Curve tables: Determine table properties (CTABID, CTABISLOCK,
CTABMEMTYP, CTABPERIOD)
Function
These commands can be used to poll important properties of a curve table (table number,
lock state, memory location, periodicity).
Syntax
CTABID(<p>)
CTABID(<p>,<memory location>)
CTABISLOCK(<n>)
CTABMEMTYP(<n>)
TABPERIOD(<n>)