Siemens SINUMERIK 828D

Flexible NC programming
1.25 Subprogram technique
Job planning
192 Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
Subprogram:
Program code Comments
PROC CONTUR_1 ...
LABEL_1 ; Start label: Start of program part execution.
N1000 G1 ...
...
LABEL_2 ; End label: End of program part execution.
...
1.25.3.7 Indirect call of a program programmed in ISO language (ISOCALL)
Function
A program programmed in an ISO language can be called using the indirect program call
ISOCALL. The ISO mode set in the machine data is then activated. The original execution
mode becomes effective again at the end of the program. If no ISO mode is set in the
machine data, the subprogram is called in Siemens mode.
For further information about the ISO mode, see
References:
ISO Dialects Functional Description
Syntax
ISOCALL <program_name>
Significance
ISOCALL: Keyword for an indirect subprogram call with which the ISO
mode set in the machine data is activated.
<program name>: Name of the program programmed in an ISO language (variable
or constant, type STRING)