Special Motion Commands
4.9 Special functions for OEM users (OEMIPO1, OEMIPO2, G810 to G829)
Job planning
272 Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
4.9 Special functions for OEM users (OEMIPO1, OEMIPO2, G810 to
G829)
Function
OEM addresses
The meaning of OEM addresses is determined by the OEM user. Their functionality is
incorporated by means of compile cycles. Five OEM addresses are reserved. The address
identifiers are settable. OEM addresses can be programmed in any block.
Parameters
Reserved G groups
Group 1 with
OEMIPO1, OEMIPO2
The OEM user can define two additional names of G functions
OEMIPO1, OEMIPO2. Their
functionality is incorporated by means of compile cycles and is reserved for the OEM user.
● Group 31 with G810 to G819
● Group 32 with G820 to G829
Two G groups with ten OEM G functions each are reserved for OEM users. These allow the
functions incorporated by an OEM user to be accessed for external applications.
Functions and subroutines
OEM users can also set up predefined functions and subroutines with parameter transfer.
To Next Page
Loading...
Need help?
General
