File and Program Management
2.1 Program memory
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
209
Example:
The workpiece directory _N_WELLE_WPD, created for SHAFT workpiece contains the
following files:
File Significance
_N_SHAFT_MPF Main program
_N_PART2_MPF Main program
_N_PART1_SPF Subprogram
_N_PART2_SPF Subprogram
_N_SHAFT_INI General initialization program for the data of the workpiece
_N_SHAFT_SEA Setting data initialization program
_N_PART2_INI General initialization program for the data for the Part 2 program
_N_PART2_UFR Initialization program for the frame data for the Part 2 program
_N_SHAFT_COM Comment file
Creating workpiece directories on an external PC
The steps described below are performed on an external data station. Please refer to your
Operator's Guide for file and program management (from PC to control system) directly on
the control.
Creating a workpiece directory with a path name ($PATH=…)
The destination path
$PATH=… is specified within the second line of the file. The file is then
stored at the specified path.
Example:
Program code
%_N_SHAFT_MPF
;$PATH=/_N_WKS_DIR/_N_SHAFT_WPD
N40 G0 X… Z…
...
M2
File _N_WELLE_MPF is stored in directory /_N_WKS_DIR/_N_WELLE_WPD.
Creating a workpiece directory without a path name
If the path name is missing, files with the _SPF extension are stored in directory
/_N_SPF_DIR, files with the _INI extension are stored in the RAM and all other files are
stored in directory/_N_MPF_DIR.
Example:
Program code
%_N_SHAFT_SPF
...
M17
File _N_WELLE_SPF is stored in directory /_N_SPF_DIR.
To Next Page
Loading...
Need help?
General
