File and Program Management
2.1 Program memory
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
211
Programming search paths for subprogram call (CALLPATH)
The CALLPATH part program command is used to extend the search path of a subprogram
call.
Example:
Program code
CALLPATH ("/_N_WKS_DIR/_N_MYWPD_WPD")
...
The search path is stored in front of position 5 (user cycle) in accordance with the specified
programming.
For further information about the programmable search path for subprogram calls with
CALLPATH, see chapter "Extending the search path for subprogram calls with CALLPATH".
To Next Page
Loading...
