Axis couplings
9.2 Curve tables (CTAB)
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
519
Significance
CTABNO
Determine total number of defined curve tables (in the static and the
dynamic NC memory)
CTABNOMEM
Determine the number of defined curve tables in the specified
<memory location>
CTABFNO
Determine the number of curve tables remaining possible in the
specified
<memory location>
CTABSEGID
Determine the number of curve segments of the specified
<segment
type>
used by curve table number <n>
CTABSEG
Determine the number of curve segments of the specified
<segment
type>
used in the specified <memory location>
CTABFSEG
Determine the number of curve segments of the specified
<segment
type>
remaining possible in the specified <memory location>
CTABMSEG
Determine the maximum possible number of curve segments of the
specified
<segment type> in the specified <memory location>
CTABPOLID
Determine the number of curve polynomials used by curve table
number
<n>
CTABPOL
Determine the number of curve polynomials used in the specified
<memory location>
CTABFPOL
Determine the number of curve polynomials remaining possible in
the specified
<memory location>
CTABMPOL
Determine the maximum possible number of curve polynomials in
the specified
<memory location>
<n>
Number (ID) of curve table
Specification of memory location (optional)
"SRAM"
Static NC memory
"DRAM"
Dynamic NC memory
<memory location>
Note:
If a value is not programmed for this parameter, the default memory
location set with
MD20905 $MC_CTAB_DEFAULT_MEMORY_TYPE is used.
Specification of segment type (optional)
"L"
Linear segments
"P"
Polynomial segments
<segment type>
Note:
If no value is programmed for this parameter, the sum of the linear
and polynomial segments is output.
To Next Page
Loading...
Need help?
General
