Siemens SINUMERIK 828D

User stock removal programs
15.3 Generate coded contour table (CONTDCON)
Job planning
700 Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
Contour table KTAB:
Column index
0 1 2 3 4 5
Line index Contour
mode
End point
abscissa
End point
ordinate
Center point
abscissa
Center point
ordinate
Feedrate
0 30 100 100 0 0 7
1 11031 20 20 0 0 200
2 111031 20 45 0 0 300
3 11031 0 45 0 0 400
4 11032 -15 30 -15 45 100
5 11031 -30 30 0 0 600
6 11031 -30 80 0 0 700
7 11031 -40 80 0 0 800
8 0 0 0 0 0 0
Explanation of the column contents:
Line 0 Coding for the starting point:
10
0
(units digit): G0 = 0 Column 0:
10
1
(tens position): G70 = 0, G71 = 1, G700 = 2, G710 = 3
Column 1: Starting point of abscissa
Column 2: Starting point of ordinate
Column 3-4: 0
Column 5: Line index of last contour piece in the table
Lines 1-n: Entries for contour pieces
10
0
(units digit): G0 = 0, G1 = 1, G2 = 2, G3 = 3
10
1
(tens position): G70 = 0, G71 = 1, G700 = 2, G710 = 3
10
2
(hundreds digit): G90 = 0, G91 = 1
10
3
(thousands digit): G93 = 0, G94 = 1, G95 = 2, G96 = 3
10
4
(ten thousands digit): G60 = 0, G44 = 1, G641 = 2, G642 = 3
Column 0:
10
5
(hundred thousands digit): G9 = 1
Column 1: End point abscissa
Column 2: End point ordinate
Column 3: Center point abscissa for circular interpolation
Column 4: Center point ordinate for circular interpolation
Column 5: Feedrate