Glossary
Job planning
802 Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
Rapid traverse
The highest traverse rate of an axis. For example, rapid traverse is used when the tool
approaches the → workpiece contour from a resting position or when the tool is retracted
from the workpiece contour. The rapid traverse velocity is set on a machine-specific basis
using a machine data element.
Reference point
Machine tool position that the measuring system of the → machine axes references.
Rotary axis
Rotary axes apply a workpiece or tool rotation to a defined angular position.
Rotation
Component of a → frame that defines a rotation of the coordinate system around a particular
angle.
Rounding axis
Rounding axes rotate a workpiece or tool to an angular position corresponding to an
indexing grid. When a grid index is reached, the rounding axis is "in position".
Safety Functions
The control is equipped with permanently active montoring functions that detect faults in the
→ CNC, the → PLC, and the machine in a timely manner so that damage to the workpiece,
tool, or machine is largely prevented. In the event of a fault, the machining operation is
interrupted and the drives stopped. The cause of the malfunction is logged and output as an
alarm. At the same time, the PLC is notified that a CNC alarm has been triggered.
Scaling
Component of a → frame that implements axis-specific scale modifications.
Selecting
Series of statements to the NC that act in concert to produce a particular → workpiece.
Likewise, this term applies to execution of a particular machining operation on a given
→ raw part.
Serial RS-232-C interface
For data input/output, the PCU 20 has one serial V.24 interface (RS232) while the
PCU 50/70 has two V.24 interfaces. Machining programs and manufacturer and user data
can be loaded and saved via these interfaces.
To Next Page
Loading...
